|
|||||||
|
|
|
|||||
|
|
|||||||
Making Of A Flair Model Fokker Triplane DR1
| Step | Photo | What done |
| 1. |  |
Fuel tank |
| 2. |  |
Front Of Fuselage |
| 3. |  |
Rear Fuselage Sides |
| 4. |  |
Full rear fuselage |
| 5. |  |
Full Fuselage |
| 6. |  |
Tailplane |
| 7. |  |
Rudder attached to fuselage |
| 8. |  |
fuselage with whole tailplane |
| 9. |  |
Top Wing |
| 10. |  |
Middle Wing |
| 11. |  |
Bottom Wing |
| 12. |  |
Undercarriage
wing |
| 13. |  |
Undercarriage added to Fuselage |
| 14. |  |
Cowling Added to fuselage |
| 15. |  |
Bottom Wing Fitted To Fuselage |
| 16. |  |
Middle Wing Fitted To Fuselage |
| 17. |  |
Fuselage Covered |
| 18. |  |
Servos and Control lines Installed |
| 19. |  |
Wings Covered Then Fitted To The Fuselage |
The Engine Was Later Added But No Photo Has Yet Been Taken Of It Due To It Being Confined To The Attic
If you want to know more about this particular model go to flairs website where details are available.
This website is NOT associated or endorsed by Flair Products
